Posts for tag: orthodontic treatment
Every year many parents learn their “tweenager” or teenager needs their bite corrected, often with specialized orthodontics. Imagine, though, if these families could go back in time to when their child’s poor bite was just developing to stop or slow it from forming.
Time travel may still be science fiction, but the approach suggested isn’t. It’s called interceptive orthodontics, a group of techniques and procedures performed during the early stages of jaw development. The focus is usually on getting abnormal jaw growth back on track, enough so that a poor bite won’t form.
The upper jaw, for example, may be growing too narrow, reducing the amount of available space for tooth eruption. If it isn’t corrected, teeth can erupt out of position. To correct it, an orthodontist places a palatal expander in the roof of the child’s mouth (palate). The appliance applies gentle pressure against the inside of the teeth, which stimulates the jaws to develop wider.
The expander works because of a separation in the bones at the center of the palate, which later fuse around puberty. The pressure applied from the expander keeps this gap slightly open; the body then continues to fill the widening expansion with bone, enough over time to widen the jaw. If you wait until puberty, the gap has already fused, and it would have to be reopened surgically to use this technique. Ideally, then, a palatal expander should be employed at a young age.
Not all interceptive techniques are this extensive—some, like a space maintainer, are quite simple. If a primary (baby) tooth is lost prematurely, teeth next to the empty space tend to drift into it and cause the intended permanent tooth to erupt out of place due to a lack of space. To prevent this an orthodontist places a small wire loop within the space to prevent other teeth from moving into it.
These are but two examples of the many methods for stopping or slowing a developing bite problem. To achieve the best outcome, they need to be well-timed. Be sure, then, to have your child undergo an orthodontic evaluation around age 6. If an interceptive orthodontic approach is needed, it could eliminate the need for more extensive—and expensive—treatment later.
After living with braces for a couple of years, the “big reveal” finally happens and you see your new smile for the first time. But then you’re told you have to wear another mouth appliance—around the clock to start and then just at night. After all the new smile excitement, wearing a retainer can be a little anticlimactic.
But this part of your orthodontic treatment is as important as the earlier tooth movement phase. That’s because your new “forever smile” doesn’t necessarily come with a “forever” guaranty. In fact, your teeth could quickly begin moving back to where they were before braces if you don’t wear a retainer.
The reason why is because of a tough but elastic gum tissue called the periodontal ligament. This ligament lies between the teeth and the jawbone, attaching to both through tiny extending fibers. The periodontal ligament actually does most of the anchoring work to hold your teeth in place.
The ligament is also why we’re able to move your teeth to different positions: As braces apply pressure to the teeth and jaw in the direction of desired movement, the ligament remodels itself to allow the teeth to take up these new positions.
The tissues involved, though, still retain a kind of “memory” of where the teeth used to be. This creates an immediate tendency for the teeth to revert to these old positions. To prevent this, we use a retainer that when worn keeps or “retains” the teeth in their new positions until they’ve stabilized and the old tissue “memory” fades.
There are different types of retainers, some removable and some fixed in place. Choosing the best one for a particular patient will depend on the complexity of the bite treatment, the patient’s age and level of self-responsibility and the preferences of the orthodontist. Whichever type of retainer you eventually use, it’s important you wear it to preserve all of the time and effort that went into transforming your smile.
Wearing a retainer might not be high on your “exciting things to do” list. But it’s the best way to guarantee you’ll enjoy your new smile for years to come.
If you would like more information on keeping your new smile after braces, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “The Importance of Orthodontic Retainers.”
Bite problems aren't limited to teeth simply out of position. The problem could be some teeth aren't there—visibly, that is. They still exist below the gums and bone, but they've been crowded out and blocked from erupting. We call this condition impaction.
Any tooth can become impacted and affect the bite, but a person's smile suffers more if it involves visible front teeth. This is especially so if the teeth in question are upper canines or "eye teeth"—the smile doesn't look normal without these pointed teeth on either side of the central and lateral incisors.
Impacted teeth can also contribute to more than a cosmetic problem: they're more susceptible to abscesses (pockets of infection) or root damage both to themselves or neighboring teeth. To minimize these potential health issues, we'll often remove impacted teeth surgically (as is often done with wisdom teeth).
But because of their important role in not only appearance but also bite function, we may first try to assist impacted canines to fully erupt before considering extraction. It takes a bit of orthodontic "magic," but it can be done.
Before we can make that decision, though, we want to precisely locate the impacted teeth's positions and how it may affect other teeth. This initial evaluation, often with advanced diagnostics like CT scanning or digital x-rays, helps us determine if the impacted teeth are in a workable position to save. If they're not, we may then need to consider removing them and ultimately replacing them with a dental implant or similar restoration.
But if their position is workable and there are no other impediments, we can proceed with helping them erupt. To do this we'll have to first expose them by creating a small opening in the gums through minor surgery. We then bond a small bracket to the tooth, to which we'll attach a small chain that we then attach to orthodontic braces. This enables us to exert continuous pressure on the tooth.
Over time, the pressure coaxes the tooth to erupt. We may still need to apply other forms of orthodontics and cosmetic procedures, but using this procedure to rescue impacted canines can produce a healthier and more attractive smile.
If you would like more information on treating complex bite problems, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Exposing Impacted Canines.”
While braces are often the stars for straightening smiles, they're not the only cast members in an orthodontic production. Orthodontists occasionally turn to other appliances if the bite problem is challenging. Whatever the tool, though, they usually have something in common—they use the principle of anchorage.
To understand anchorage, let's first consider the classic kid's game Tug of War. With teams on either end of a rope, the object is to pull the opposing team across the center line before they pull you. To maximize your pulling force, the player at the back of your rope, usually your stoutest member, holds steady or "anchors" the rest of the team.
Like a Tug of War team, braces exert force against the teeth. This stimulates the supporting periodontal ligament to remodel itself and allow the teeth to move. The braces use the teeth they are attached to as anchors, which in a lot of cases are the back teeth. By attaching a thin wire to the brackets or braces on the teeth, the orthodontist includes all the teeth on the arch, from one end to the other. Anchored in place, the wire can maintain a constant pressure against the teeth to move them.
But not all bite situations are this straightforward. Sometimes an orthodontist needs to influence jaw growth in addition to teeth movement. For this purpose, they often use orthodontic headgear, which runs around the back of the head or neck and attaches to orthodontic brackets on the teeth. It still involves an anchor but in this case it's the patient's own skull.
In some situations, an orthodontist may feel he or she needs more anchorage as the teeth alone may not be enough. For this, they might establish a separate or additional anchor point using a temporary anchorage device (TAD). A TAD resembles a tiny screw that's inserted into the jawbone near the tooth intended for movement. The orthodontist can then attach the TAD to braces hardware using some form of elastics. After treatment, they remove the TAD.
These are just a couple examples of specialized tools an orthodontist can use for bite correction. Thanks to them and similar devices, even the most complex bite problem can be overcome to create a healthier and more attractive smile.
If you would like more information on correcting a poor bite, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Orthodontic Headgear & Other Anchorage Appliances.”
It’s a big moment after months of wearing braces to finally get a glimpse of your new smile. The crooked teeth and poor bite are gone — and in their place are beautiful, straight teeth!
If you’re not careful, though, your new look might not last. That’s because the natural mechanism we used to straighten your teeth may try to return them to their previous poor positions.
Contrary to what many people think, teeth aren’t rigidly set within the jaw bone. Instead, an elastic, fibrous tissue known as the periodontal ligament lies between the teeth and the bone and attaches to both with tiny fibers. Though quite secure, the attachment allows the teeth to move in very minute increments in response to growth or other changes in the mouth.
Orthodontic appliances like braces or clear aligners put pressure on the teeth in the direction we wish them to move. The bone dissolves on the side of the teeth where pressure is being applied or facing the direction of movement and then builds up on the other side where tension is occurring.
The ligament, though, has a kind of “muscle memory” for the teeth’s original position. Unless it’s prevented, this “memory” will pull the teeth back to where they used to be. All the time and effort involved with wearing braces will be lost.
That’s why it’s important for you to wear an appliance called a retainer after your braces have been removed. As the name implies, the appliance “retains” the teeth in their new position until it’s more permanently set. For most people, this means wearing it for twenty-four hours in the beginning, then later only a few hours a day or while you sleep.
The majority of younger patients eventually won’t need to wear a retainer once bone and facial growth has solidified their teeth’s new position. Older adults, though, may need to wear one from now on. Even so, it’s a relatively slight inconvenience to protect that beautiful, hard-won smile.
If you would like more information on retainers, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “The Importance of Orthodontic Retainers.”